БЛОК ДВИГАТЕЛЯ > ЗАМЕНА

для подготовки Нажмите здесь



1. REPLACE TIMING CHAIN COVER STRAIGHT PIN


    A148443E01

  1. Remove the straight pin.

  1. Using a plastic-faced hammer, tap in new straight pins to the timing chain cover.

    Standard protrusion:
    5.5 to 6.5 mm (0.217 to 0.256 in.)



2. REPLACE TIMING CHAIN COVER RING PIN


    A148442E01

  1. Remove the ring pin.

  1. Using a plastic-faced hammer, tap in new ring pins to the timing chain cover.

    Standard protrusion:
    Item
    		Specified Condition
    Ring pin A
    		7.5 to 8.5 mm (0.295 to 0.335 in.)
    Ring pin B
    		3.6 to 4.6 mm (0.142 to 0.181 in.)



3. REPLACE OIL PAN STUD BOLT

  1. Remove the 2 stud bolts.



    A148437E01

  1. Using an E6 "TORX" socket wrench, install the 2 stud bolts as shown in the illustration.

    Момент затяжки: 
    5.0 Н*м{ 51 кгс*см , 44 фунт-сила-дюймов }



4. REPLACE ENGINE REAR OIL SEAL


    A145614E01

  1. Place the oil seal retainer on wooden blocks.

  1. Using a screwdriver and hammer, tap out the oil seal.



    A148433E01

  1. Using SST, tap in a new oil seal until its surface is flush with the oil seal retainer edge.

    Специальный инструмент (SST):
    09223-15030  
    09950-70010   (09951-07100)

    ПРИМЕЧАНИЕ:
    1. Keep the lip free from foreign matter.
    2. Do not tap on the oil seal at an angle.