КОНТАКТНЫЙ ДАТЧИК ДАВЛЕНИЯ МАСЛА > УСТАНОВКА

для подготовки Нажмите здесь



1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    A050082E19

  1. Apply adhesive to 2 or 3 threads of the switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A145214

  1. Using a 24 mm deep socket wrench, install the switch.

    Момент затяжки: 
    15 Н*м{ 153 кгс*см , 11 фунт-сила-футов }

    ПРИМЕЧАНИЕ:
    Do not start the engine within 1 hour after installation.

  1. Connect the switch connector.



2. INSTALL NO. 1 ENGINE UNDER COVER


    A132845

  1. Install the cover with the 7 clips and 13 screws.



3. INSPECT FOR ENGINE OIL LEAK

  1. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.