ЭЛЕКТРОДВИГАТЕЛЬ МЕХАНИЗМА ИЗМЕНЕНИЯ ФАЗ ГАЗОРАСПРЕДЕЛЕНИЯ > ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

для подготовки Нажмите здесь



1. INSPECT FUNCTION OF CAMSHAFT TIMING CONTROL MOTOR

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Start the engine and warm it up.

  1. Engine is idling.

  1. Enter the following menus: Powertrain / Engine / Active Test / Control the MD VVT Linear (Bank1) or Control the MD VVT Linear (Bank2) / All Data / MD VVT Aim Angle (Bank1) and MD VVT Change Angle (Bank1) or MD VVT Aim Angle (Bank2) and MD VVT Change Angle (Bank2).

  1. Perform the "Control the MD VVT Linear (Bank1) or Control the MD VVT Linear (Bank2)" .

    OK:

    Active Test Movement Order
    		Difference between "MD VVT Aim Angle" and "VVT Change Angle"
    0° → 10° → 20° → 40° → 10° → 0° → 10° → END
    		Within 4°

    If not within the standard, inspect the camshaft timing control motor assembly and camshaft timing gear assembly.



2. INSPECT CAMSHAFT TIMING CONTROL MOTOR


A150417E01

  1. Rotate the joint of the camshaft timing control motor assembly by hand.

    Standard:
    Rotates smoothly.

    ПРИМЕЧАНИЕ:
    1. Do not drop the camshaft timing control motor assembly. If dropped, replace the camshaft timing control motor assembly.
    2. Do not disassemble the camshaft timing control motor assembly. If disassembled, replace the camshaft timing control motor assembly.
    3. Do not allow foreign matter to contact the oil seal face of the camshaft timing control motor (connecting surface with timing chain cover sub-assembly).
    If not as specified, replace the camshaft timing control motor assembly.