ПРОКЛАДКА ГОЛОВКИ БЛОКА ЦИЛИНДРОВ (для ряда 2) > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCHARGE FUEL SYSTEM PRESSURE

  1. Discharge fuel system pressure (see page Нажмите здесь).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРЕДОСТЕРЕЖЕНИЕ:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE CAMSHAFT (for Bank 2)

  1. Remove the camshaft (see page Нажмите здесь).



4. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

  1. Remove the 16 valve rocker arms from the cylinder head.

    УКАЗАНИЕ:
    Arrange the removed parts in the correct order.



5. REMOVE VALVE LASH ADJUSTER ASSEMBLY

  1. Remove the 16 valve lash adjusters from the cylinder head.

    УКАЗАНИЕ:
    Arrange the removed parts in the correct order.



6. REMOVE VALVE STEM CAP

  1. Remove the 16 valve stem caps from the cylinder head.

    УКАЗАНИЕ:
    Arrange the removed parts in the correct order.



7. REMOVE CYLINDER HEAD SUB-ASSEMBLY (for Bank 2)


    A148236E01

  1. Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.



    A148237E01

  1. Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

    ПРИМЕЧАНИЕ:
    1. Be careful not to drop washers into the cylinder head.
    2. Head warpage or cracking could result from removing bolts in an incorrect order.

    УКАЗАНИЕ:
    Be sure to keep the removed parts separate for each installation position.

  1. Remove the cylinder head and gasket.