БЛОК ЦИЛИНДРОВ > ЗАМЕНА

для подготовки Нажмите здесь



1. REPLACE STRAIGHT PIN

ПРИМЕЧАНИЕ:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.



  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.


    A142823E02

    Standard protrusion:
    Item
    		Specified Condition
    Pin A
    		23 mm (0.9055 in.)
    Pin B
    		11 mm (0.4331 in.)
    Pin C
    		9 mm (0.3543 in.)
    Pin D
    		6 mm (0.2362 in.)



2. REPLACE STUD BOLT

ПРИМЕЧАНИЕ:
If a stud bolt is deformed or the threads are damaged, replace it.

  1. Remove the stud bolts.



  1. Using an E8 and E10 "TORX" socket wrench, install the stud bolts.


    A142822E02

    Момент затяжки: 
    10 Н*м{ 102 кгс*см , 7 фунт-сила-футов } for Stud bolt A
    9.0 Н*м{ 92 кгс*см , 80 фунт-сила-дюймов } for Stud bolt B



3. REPLACE TIGHT PLUG

ПРИМЕЧАНИЕ:
If water leaks from the tight plug or the plug corrodes, replace it.

  1. Remove the tight plug.



    A132063E01

  1. Apply adhesive around the tight plug.

    Adhesive: :
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A142821E01

  1. Using SST and a hammer, tap in the tight plug as shown in the illustration.

    Специальный инструмент (SST):
    09950-60010   (09951-00200)
    09950-70010   (09951-07100)