| Last Modified: 4-30-2014 | 6.6 D | Doc ID: RM000000PLO009X |
| Model Year: 2006 | Model: LX470 | Prod Date Range: [05/2005 - ] |
| Title: CRUISE CONTROL: CRUISE CONTROL SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING; 2006 MY LX470 [05/2005 - ] | ||
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
- Use these procedures to troubleshoot the cruise control system.
- *: Use the intelligent tester.
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
10 to 14 V
If the voltage is below 10 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* |
(a) Use the intelligent tester (with CAN VIM) to check if the Multiplex Communication System (MPX) is functioning normally.
Result:
|
Result |
Proceed to |
|---|---|
|
MPX DTC is not output |
A |
|
MPX DTC is output |
B |
| B |
|
Go to MULTIPLEX COMMUNICATION SYSTEM |
|
|
4. |
CHECK INDICATOR LIGHT |
|
|
5. |
CHECK DTC* |
(a) Check for DTC and note any codes that are output.
(b) Delete the DTC.
(c) Recheck for DTCs, and try to prompt the DTC by simulating the original activity that the DTC suggests.
|
Result |
Proceed to |
|---|---|
|
DTC does not reoccur |
A |
|
DTC reoccurs |
B |
| B |
|
Go to step 8 |
|
|
6. |
PROBLEM SYMPTOMS TABLE |
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B |
|
Go to step 8 |
|
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a)
Terminals of ECM
![2006 MY LX470 [05/2005 - ]; CRUISE CONTROL: CRUISE CONTROL SYSTEM: TERMINALS OF ECM](../../../../stylegraphics/info.gif "2006 MY LX470 [05/2005 - ]; CRUISE CONTROL: CRUISE CONTROL SYSTEM: TERMINALS OF ECM")
(b)
DATA LIST/ACTIVE TEST
|
|
8. |
ADJUST, REPAIR OR REPLACE |
|
|
9. |
CONFIRMATION TEST |
| NEXT |
|
END |
|
|