Last Modified: 4-30-2014 6.6 C Doc ID: RM000000TA1009X
Model Year: 2006 Model: LX470 Prod Date Range: [05/2005 -           ]
Title: 2UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0630; VIN not Programmed or Mismatch - ECM / PCM; 2006 MY LX470 [05/2005 -        ]

DTC

P0630

VIN not Programmed or Mismatch - ECM / PCM

DESCRIPTION

DTC P0630 is set if the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the intelligent tester 2006 MY LX470 [05/2005 -        ]; 2UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: REGISTRATION .

DTC No.

DTC Detection Condition

Trouble Area

P0630

  • VIN not stored in ECM
  • Input VIN in ECM not accurate

ECM

MONITOR STRATEGY

Related DTCs

P0630: VIN not programmed

Required Sensors/Components (Main)

ECM

Required Sensors/Components (Related)

-

Frequency of Operation

Continuous

Duration

0.5 seconds

MIL Operation

Immediate

Sequence of Operation

None

TYPICAL ENABLING CONDITIONS

The monitor will run whenever this DTC is not present

-

Battery voltage

8 V or more

Ignition switch

ON

Starter

OFF

TYPICAL MALFUNCTION THRESHOLDS

VIN code

Not programmed

COMPONENT OPERATING RANGE

VIN code

Programmed

INSPECTION PROCEDURE

PROCEDURE

1.

READ CURRENT DTC

(a) Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.

(b) Turn the ignition switch ON and turn the tester ON.

(c) Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DAC INFO / CURRENT CODES.

(d) Read DTCs.

Result

Display (DTC Output)

Proceed to

P0630

A

P0630 and other DTCs

B

  • If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTICE:

If P0630 is set, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the tester when inputting the VIN. If DTCs other than P0630 are set, check them first.

B

GO TO DTC CHART

A

2.

INPUT VIN WITH INTELLIGENT TESTER

(a) Input VIN with intelligent tester 2006 MY LX470 [05/2005 -        ]; 2UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: REGISTRATION .

NEXT

END