A750F AUTOMATIC TRANSMISSION: VALVE BODY ASSEMBLY: REMOVAL; 2006 MY LX470 [05/2005

Last Modified: 4-30-2014	6.6 A	Doc ID: RM0000013CM004X
Model Year: 2006	Model: LX470	Prod Date Range: [05/2005 - ]
Title: A750F AUTOMATIC TRANSMISSION: VALVE BODY ASSEMBLY: REMOVAL; 2006 MY LX470 [05/2005 - ]

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. DRAIN AUTOMATIC TRANSMISSION FLUID

(a) Remove the drain plug and gasket, and drain ATF.

(b) Install a new gasket and the drain plug.

Torque:

20 N·m {204 kgf·cm, 15ft·lbf}

3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

NOTICE:

Some fluid will remain in the oil pan.

(a) Remove the 20 bolts and oil pan.

(b) Examine the particles in the oil pan.

(1) Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

Steel (magnetic): bearing, gear and clutch plate wear

Brass (non-magnetic): bushing wear

4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

(a) Remove the 4 bolts and oil strainer.

NOTICE:

Be careful as some fluid may leak out of the oil strainer.

5. DISCONNECT TRANSMISSION WIRE

(a) Remove the 2 bolts and clamp.

(b) Disconnect the ATF temperature sensor.

6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

(a) Remove the 19 bolts and valve body.

(b) Remove the 3 drum seal gaskets.