| Last Modified: 4-30-2014 | 6.6 J | Doc ID: RM0000018H1000X |
| Model Year: 2006 | Model: LX470 | Prod Date Range: [05/2005 - ] |
| Title: THEFT DETERRENT: THEFT DETERRENT SYSTEM: Power Source Circuit; 2006 MY LX470 [05/2005 - ] | ||
|
Power Source Circuit |
DESCRIPTION
This circuit provides power to operate the theft warning ECU assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
INSPECT FUSE (SECURITY, ECU-B2, BAT, ECU-IG1, AM1) |
(a) Remove the SECURITY and ECU-B2 fuses from the cowl side junction block RH.
(b) Remove the BAT fuse from the engine room junction block.
(c) Remove the ECU-IG1 and AM1 fuses from the cowl side junction block LH.
(d) Measure the resistance of the fuses.
Standard resistance:
Below 1 Ω
| NG |
|
|
|
2. |
CHECK WIRE HARNESS (THEFT WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND) |
(a) Disconnect the T6 ECU connector.
(b) Measure the resistance and voltage of the wire harness side connector.
Standard resistance:
|
Tester Connection |
Specified Condition |
|---|---|
|
T6-29 (E) - Body ground |
Below 1 Ω |
Standard voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
T6-2 (+B1) - Body ground |
Always |
10 to 14 V |
|
T6-3 (+B2) - Body ground |
Always |
10 to 14 V |
|
T6-10 (IG) - Body ground |
Ignition switch OFF |
Below 1 V |
|
Ignition switch ON |
10 to 14 V |
| NG |
|
| OK |
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE |
|
|