|
Last Modified: 4-30-2014 |
6.6 J |
Doc ID: RM000001A0L002X |
|
Model Year: 2006 |
Model: LX470 |
Prod Date Range: [05/2005 -
] |
|
Title: DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: Door Lock Motor Circuit; 2006 MY LX470 [05/2005 - ] |
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When using the intelligent tester, start from *1. When not using the intelligent tester, start from *2.
PROCEDURE
|
1.
|
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DOOR LOCK MOTOR) *1
|
(a) Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the door lock motor operates normally.
| OK |
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE
|
| NG |
|
|
|
2.
|
INSPECT DOOR LOCK MOTOR *2
|
(a)
Inspect the front door lock motor
.
(b)
Inspect the rear door lock motor
.
| NG |
|
REPLACE DOOR LOCK MOTOR
|
| OK |
|
|
|
3.
|
CHECK WIRE HARNESS (MOTOR - BODY ECU (MAIN))
|
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR
|
| OK |
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE
|
|