Last Modified: 4-30-2014 6.6 J Doc ID: RM000001BTN002X
Model Year: 2006 Model: LX470 Prod Date Range: [05/2005 -           ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: VSC Warning Light Remains ON; 2006 MY LX470 [05/2005 -        ]

VSC Warning Light Remains ON

DESCRIPTION

When checking for a 2 digit DTC, the VSC TRAC warning light may remain on.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1.

INSPECT SKID CONTROL ECU CONNECTOR

(a) Check that each ECU connector is properly installed.

OK:

Each ECU connector is properly installed.

NG

CONNECT CONNECTOR TO ECU CORRECTLY

OK

2.

CHECK FOR DTC

(a) Turn the ignition swith ON.

(b) Check that the VSC TRAC warning light illuminates.

(c) Check if the same DTCs are recorded.

Result:

Result

Proceed to

DTC is not output

A

DTC is output

B

B

REPAIR CIRCUIT INDICATED BY OUTPUT DTC

A

3.

CHECK VSC TRAC WARNING LIGHT REMAIN ON

NG

END

OK

4.

INSPECT BATTERY

Result:

Result

Proceed to

Battery voltage is OK (when using intelligent tester)

A

Battery voltage is OK (when not using intelligent tester)

B

Battery voltage is NG

C

B

GO TO STEP 6

C

RECHARGE OR REPLACE BATTERY

A

5.

PERFORM ACTIVE TEST BY INTELLIGENT TESTER (VSC TRAC WARNING LIGHT)

(a) Select the ACTIVE TEST, generate a control command, and then check that the VSC TRAC warning light operates.

Skid control ECU assembly

Item

Vehicle Condition / Test Details

Diagnostic Note

VSC WARN LIGHT

Turn VSC warning light ON / OFF

Observe combination meter

OK:

VSC TRAC warning light on or off.

OK

REPLACE SKID CONTROL ECU ASSEMBLY

NG

6.

CHECK VSC TRAC WARNING LIGHT

(a) Disconnect the A40 ECU connector.

(b) Turn the ignition switch ON.

(c) Using a service wire, connect terminal WA to GND3 or GND4 of the A40 ECU connector. Check the VSC TRAC warning light.

OK:

VSC TRAC warning light turns off.

(d) Turn the ignition switch OFF.

(e) Remove the service wire.

(f) Turn the ignition switch ON. Check the VSC TRAC warning light.

OK:

VSC TRAC warning light illuminates.

OK

REPLACE SKID CONTROL ECU ASSEMBLY

NG

7.

CHECK WIRE HARNESS (SKID CONTROL ECU ASSEMBLY - COMBINATION METER)

OK

REPAIR OR REPLACE HARNESS AND CONNECTOR

OK

REPLACE COMBINATION METER