|
Last Modified: 4-30-2014 |
6.6 J |
Doc ID: RM000001BU6002X |
|
Model Year: 2006 |
Model: LX470 |
Prod Date Range: [05/2005 -
] |
|
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: VSC OFF Indicator Light Circuit; 2006 MY LX470 [05/2005 - ] |
|
VSC OFF Indicator Light Circuit
|
DESCRIPTION
This is the VSC control main switch. When the center differential is locked, VSC control goes off and the VSC OFF indicator light lights up.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When using the intelligent tester, start from *1. When not using the intelligent tester, start from *2.
PROCEDURE
|
1.
|
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC OFF INDICATOR)*1
|
(a) Select the ACTIVE TEST, generate a control command, and then check that the VSC OFF indicator light operates.
Skid control ECU
|
Item
|
Vehicle Condition / Test Details
|
Diagnostic Note
|
|
VSC/ TRC OFF IND
|
Turn VSC/TRC OFF indicator ON / OFF
|
Observe combination meter
|
OK:
VSC OFF indicator turns on or off.
| OK |
|
|
(a) Turn the ignition switch ON.
(b) Check that the the VSC TRAC warning light illuminates.
(c) Check if the same DTCs are recorded.
Result:
|
Result
|
Proceed to
|
|
DTC is not output
|
A
|
|
DTC is output
|
B
|
| B |
|
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
|
| A |
|
|
(a) Check the warning lights other than VSC OFF indicator light.
| NG |
|
|
|
4.
|
INSPECT RELAY (Marking: IG1 NO. 2)
|
|
(a) Remove the IG1 NO. 2 relay from the cowl side junction block LH.
(b) Measure the resistance of the relay.
Standard resistance:
|
Tester Connection
|
Specified Condition
|
|
1 - 2
|
10 kΩ or higher
|
|
1 - 2
|
Below 1 Ω
(when battery voltage is applied to terminals 3 and 4)
|
|
|
| NG |
|
REPLACE RELAY
|
| OK |
|
CHECK COMBINATION METER (COMBINATION METER CIRCUIT)
|
|
5.
|
CHECK VSC OFF INDICATOR LIGHT
|
(a) Check for open circuit in the combination meter circuit.
| NG |
|
REPLACE COMBINATION METER
|
| OK |
|
|
|
6.
|
CHECK WIRE HARNESS (SKID CONTROL ECU ASSEMBLY - VSC OFF INDICATOR LIGHT)
|
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR
|
| OK |
|
|
|
7.
|
INSPECT CENTER DIFFERENTIAL SWITCH
|
(a)
Check the center differential switch
.
| NG |
|
REPLACE CENTER DIFFERENTIAL SWITCH
|
| OK |
|
|
|
8.
|
CHECK WIRE HARNESS (CENTER DIFFERENTIAL SWITCH - BODY GROUND)
|
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR
|
| OK |
|
REPLACE SKID CONTROL ECU ASSEMBLY
|
|