|
Last Modified: 4-30-2014 |
6.6 A |
Doc ID: RM000001CGV001X |
|
Model Year: 2006 |
Model: LX470 |
Prod Date Range: [05/2005 -
] |
|
Title:
TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER: REMOVAL; 2006 MY LX470 [05/2005 - ]
|
REMOVAL
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
(a)
Remove the lower frame bracket garnish
.
3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a)
Remove the regulator switch
.
4. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL
(a)
Remove the inside handle bezel
.
5. REMOVE NO. 1 DOOR INSIDE HANDLE BEZEL
(a)
Remove the inside handle bezel
.
6. REMOVE FRONT DOOR COURTESY LIGHT
(a)
Remove the courtesy light
.
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
(a)
Remove the trim board
.
8. REMOVE TWEETER SPEAKER
(a)
Remove the tweeter speaker
.
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(a) w/ Tire pressure monitor receiver:
(1)
Remove the rear view mirror
.
10. REMOVE OUTER MIRROR RETRACTOR
(a) w/ Tire pressure monitor receiver:
(1)
Remove outer mirror retractor
.
|