- Center differential lock position switch
- Suspension control ECU
- Wire harness
| Last Modified: 4-30-2014 | 6.6 C | Doc ID: RM000001CUC002X |
| Model Year: 2006 | Model: LX470 | Prod Date Range: [05/2005 - ] |
| Title: SUSPENSION CONTROL: ACTIVE HEIGHT CONTROL SUSPENSION: C1796/96; Differential Lock Detect Signal Circuit Malfunction; 2006 MY LX470 [05/2005 - ] | ||
|
DTC |
C1796/96 |
Differential Lock Detect Signal Circuit Malfunction |
DESCRIPTION
This circuit sends the signal to the ECU by detecting that the transfer differential is in the LOCK condition.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C1796/96 |
Center differential lock position switch signal does not change |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When using the intelligent tester, start from *1. When not using the intelligent tester, start from *2.
PROCEDURE
|
1. |
READ VALUE USING INTELLIGENT TESTER (CENTER DIFFERENTIAL LOCK POSITION SWITCH)*1 |
(a) Connect the intelligent tester (with CAN VIM) to the DLC3.
(b) Turn the ignition switch ON and push the intelligent tester main switch ON.
(c) Select the DATA LIST mode on the intelligent tester.
(d) Check the center differential lock switch condition displayed on the intelligent tester when pushing the center differential lock switch.
OK:
When the center differential lock switch pushed once
ON is displayed for the center differential lock position switch condition.
When the center differential lock switch pushed twice
OFF is displayed for the center differential lock position switch condition.
| NG |
|
| OK |
|
|
2. |
CHECK SUSPENSION CONTROL ECU*2 |
|
(a) Remove the suspension control ECU with connectors still connected. |
|
(b) Turn the ignition switch ON.
(c) Measure the voltage between terminal EXI of the suspension control ECU connector and body ground when the center differential lock switch is pushed twice.
Standard voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
S6-18 (EXI) - Body ground |
Pushed once |
Below 1.5 V |
|
S6-18 (EXI) - Body ground |
Pushed twice |
9 to 14 V |
| NG |
|
|
|
3. |
INSPECT CENTER DIFFERENTIAL LOCK POSITION SWITCH |
|
(a) Disconnect the center differential lock position switch connector. |
|
(b)
Remove the center differential lock position switch
![2006 MY LX470 [05/2005 - ]; HF2A TRANSFER: TRANSFER ASSEMBLY: COMPONENTS](../../../../stylegraphics/info.gif "2006 MY LX470 [05/2005 - ]; HF2A TRANSFER: TRANSFER ASSEMBLY: COMPONENTS")
.
(c) Measure the resistance between terminals 1 and 2 of center differential lock switch connector when the center differential lock position switch pushed and released.
Standard resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
1 - 2 |
Pushed |
Below 1 Ω |
|
1 - 2 |
Released |
10 kΩ or higher |
| NG |
|
|
|
4. |
CHECK WIRE HARNESS (CENTER DIFFERENTIAL LOCK POSITION SWITCH - SUSPENSION CONTROL ECU) |
| NG |
|
| OK |
|
|
|