|
Last Modified: 4-30-2014 |
6.6 C |
Doc ID: RM000001F7O000X |
|
Model Year: 2006 |
Model: LX470 |
Prod Date Range: [05/2005 -
] |
|
Title: CELLULAR COMMUNICATION: LEXUS LINK SYSTEM: 3-2; Cellular Phone Antenna Error; 2006 MY LX470 [05/2005 - ] |
|
DTC
|
3-2
|
Cellular Phone Antenna Error
|
DESCRIPTION
This DTC is output when one of the following occurs: 1) the mayday ECU assembly is malfunctioning; 2) the telephone antenna (cellular phone antenna) is malfunctioning; or 3) the wire harness between the mayday ECU assembly and the telephone antenna is open or short.
|
DTC No.
|
DTC Detection Condition
|
Trouble Area
|
|
3 - 2
|
Communication or communication line is abnormal between mayday ECU and telephone antenna (cellular phone antenna)
|
-
Mayday ECU assembly
-
Telephone antenna (Cellular phone antenna)
-
Wire harness
|
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1.
|
INSPECT TELEPHONE ANTENNA
|
|
(a) Disconnect the antenna connector from the ECU.
|
|
(b) Measure the resistance of the antenna.
Standard resistance:
|
Tester Connection
|
Specified Condition
|
|
1 (SIGNAL) - Body ground
|
4 to 11 kΩ
|
| NG |
|
|
|
2.
|
CHECK WIRE HARNESS (MAYDAY ECU ASSEMBLY - TELEPHONE ANTENNA)
|
|
(a) Disconnect the M17 ECU connector.
(b) Disconnect the T34 antenna connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:
|
Tester Connection
|
Specified Condition
|
|
M17-1 (SIGNAL) - T34-1 (SIGNAL)
|
Below 1 Ω
|
|
M17-1 (SIGNAL) or T34-1 (SIGNAL) - Body ground
|
10 kΩ or higher
|
|
|
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR THEN CLEAR HISTORIC DTC
|
| OK |
|
|
|
3.
|
CHECK OPERATION OF MAYDAY ECU ASSEMBLY
|
(a) Temporarily replace the mayday ECU and mayday battery with a new one.
(b) Check for DTC again.
OK:
System operates normally (red LED off).
NG:
Current DTC 3-2 exists
| OK |
|
END (PERFORM REGISTRATION)
|
| NG |
|
REPLACE TELEPHONE ANTENNA THEN CLEAR HISTORIC DTC
|
|