No-load characteristics

Current: 100 A or less at 11.5 V

Starter armature assembly

Maximum runout: 0.05 mm (0.002 in.)

Standard diameter: 35.0 mm (1.378 in.)

Minimum diameter: 34.0 mm (1.339 in.)

Standard undercut depth: 0.7 mm (0.028 in.)

Minimum undercut depth: 0.2 mm (0.008 in.)

Starter yoke assembly

Terminal - Terminal: 1.5 to 1.9 Ω

Brush lenght

Standard: 15.0 mm (0.591 in.)

Minimum: 9.0 mm (0.354 in.)

Brush spring load

Standard: 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.8 to 6.2 lbf)

Minimum: 12.7 Nm (1.3 kgf, 2.9 lbf)

Starter relay

3 - 5: 10 kΩ or higher

3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

ACC relay

3 - 4: Below1 Ω

3 - 5: 10 kΩ or higher

3 - 4: 10 kΩ or higher (when battery voltage is applied to terminals 1 and 2)

3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

Ignition switch

LOCK: Between all terminals 10 kΩ or higher

ACC: 2 (AM1) - 3 (ACC) Below 1 Ω

ON: 2 (AM1) - 3 (ACC) Below 1 Ω

ON: 2 (AM1) - 4 (IG1) Below 1 Ω

ON: 6 (IG2) - 7 (AM2) Below 1 Ω

START: 1 (ST1) - 2 (AM1) Below 1 Ω

START: 1 (ST1) - 4 (IG1) Below 1 Ω

START: 6 (IG2) - 7 (AM2) Below 1 Ω

START: 6 (IG2) - 8 (ST2) Below 1 Ω