Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM000000PXT00BX
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: 2UZ-FE LUBRICATION: OIL FILTER: REPLACEMENT; 2007 MY LX470 [08/2006 -        ]

REPLACEMENT

CAUTION:

  • Prolonged and repeated contact with mineral oil will result in the loss of natural oil from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
  • Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash the area thoroughly with soap and waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.
  • In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.

1. DRAIN ENGINE OIL

(a) Remove the oil filler cap.

(b) Remove the 2 bolts and No. 3 engine under cover.

(c) Remove the oil drain plug and drain the oil into a container.

2. REMOVE OIL FILTER ASSEMBLY

(a) Remove the 2 bolts and service hole cover.

(b) Using SST, remove the oil filter.

SST: 09228-07501

3. INSTALL OIL FILTER ASSEMBLY

(a) Clean and check the oil filter installation surface.

(b) Apply clean engine oil to the gasket of a new oil filter.

(c) Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.

(d) Using SST, tighten the oil filter.

SST: 09228-07501

(1) Depending on the workspace available, choose from the following.

  • If enough space is available, use a torque wrench to tighten the oil filter.

Torque:

17.2 N·m {178 kgf·cm, 13ft·lbf}

  • If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or with a common wrench.

4. ADD ENGINE OIL

(a) Install a new gasket and the drain plug.

Torque:

39 N·m {398 kgf·cm, 29ft·lbf}

(b) Add new oil.

Standard oil capacity:

Item

Capacity

Drain and refill with oil filter change

6.8 liters (7.2 US qts, 6.0 Imp. qts)

Drain and refill without oil filter change

6.4 liters (6.8 US qts, 5.6 Imp. qts)

Dry fill

8.0 liters (8.5 US qts, 7.0 Imp. qts)

(c) Reinstall the oil filler cap.

5. CHECK FOR ENGINE OIL LEAKS

6. CHECK ENGINE OIL LEVEL 2007 MY LX470 [08/2006 -        ]; 2UZ-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION+

7. INSTALL NO. 3 ENGINE UNDER COVER

(a) Install the engine under cover with the 2 bolts.

8. INSTALL SERVICE HOLE COVER

(a) Install the service hole cover with the 2 bolts.