| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000010N900TX |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: A750F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION; 2007 MY LX470 [08/2006 - ] | ||
INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the park/neutral position switch to the manual valve shaft.
(b) Temporarily install the bolt.
(c) Install a new lock washer and the nut.
Torque:
7.0 N·m {71 kgf·cm, 62in·lbf}
|
(d) Turn the control shaft fully rearward, and return the control shaft lever 2 notches to the N position. |
|
|
(e) Align the neutral basic line with the switch groove, and tighten the bolt. Torque: 13 N·m {130 kgf·cm, 9ft·lbf} |
|
(f) Using a screwdriver, bend the tabs of the lock washer.
2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a)
Perform initialization
![2007 MY LX470 [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](../../../../stylegraphics/info.gif "2007 MY LX470 [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION")
.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. INSPECT SHIFT LEVER POSITION
6. ADJUST SHIFT LEVER POSITION
7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a)
Inspect park/neutral position switch assembly
.
|
|