| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000017HK005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: 2UZ-FE ENGINE CONTROL SYSTEM: ACCELERATOR PEDAL POSITION SENSOR: ON-VEHICLE INSPECTION; 2007 MY LX470 [08/2006 - ] | ||
ON-VEHICLE INSPECTION
1. CHECK ACCELERATOR PEDAL
|
(a) Connect the intelligent tester (with CAN VIM) to the DLC3. |
|
(b) Turn the ignition switch ON.
(c) Push the intelligent tester main switch ON.
(d) Select the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ACCEL POS #1, ACCEL POS #2.
(e) When depressing and releasing the accelerator pedal, check that the values of the accelerator POS No. 1 and POS No. 2 are within the specification.
Accelerator POS No. 1 standard voltage:
|
Condition |
Specified Condition |
|---|---|
|
Accelerator pedal is released |
0.5 to 1.1 V |
|
Accelerator pedal is depressed |
2.6 to 4.5 V |
Accelerator POS No. 2 standard voltage:
|
Condition |
Specified Condition |
|---|---|
|
Accelerator pedal is released |
1.2 to 2.0 V |
|
Accelerator pedal is depressed |
3.4 to 5.0 V |
If the result is not as specified, check the accelerator pedal, wire harness or ECM.
|
|