|
Last Modified: 7-3-2017 |
6.8:8.0.40 |
Doc ID: RM0000017WW005X |
|
Model Year Start: 2007 |
Model: LX470 |
Prod Date Range: [08/2006 -
] |
|
Title: MULTIPLEX COMMUNICATION: MULTIPLEX COMMUNICATION SYSTEM: B1272; Power Seat ECU Communication Stop; 2007 MY LX470 [08/2006 - ] |
|
DTC
|
B1272
|
Power Seat ECU Communication Stop
|
DESCRIPTION
HINT:
"Power seat ECU" refer to the position control ECU (driver seat ECU).
-
This DTC is output when communication between the position control ECU (driver seat ECU) and multiplex network body ECU (main).
|
DTC No.
|
DTC Detection Condition
|
Trouble Area
|
|
B1272
|
No signal from position control ECU assembly (Driver seat ECU) for more than 10 seconds.
|
-
Position control ECU assembly (Driver seat ECU)
-
Wire harness
|
WIRING DIAGRAM
-
Refer to DTC B1214 and 1215
.
INSPECTION PROCEDURE
PROCEDURE
|
1.
|
CHECK POSITION CONTROL ECU ASSEMBLY (DRIVER SEAT ECU)
|
(a) Check that the seat's front vertical and rear vertical operations are normal.
HINT:
With this inspection, whether or not the position control ECU (driver seat ECU) CPU functions normally can be diagnosed.
| NG |
|
REPLACE POSITION CONTROL ECU ASSEMBLY (DRIVER SEAT ECU)
|
| OK |
|
|
|
2.
|
CHECK WIRE HARNESS (POSITION CONTROL ECU ASSEMBLY - MULTIPLEX NETWORK BODY ECU (MAIN) AND MIRROR CONTROL ECU)
|
(a) Disconnect the ECU connectors mentioned in the table below.
(b) Check the continuity of the wire harness between the connectors.
|
Wire harness side connector of ECU
|
Terminal
|
|
Position control ECU assembly (Driver seat ECU) - Multiplex network body ECU (Main)
|
S28-4 (MPX1) - B7-23 (MPX2)
|
|
Position control ECU assembly (Driver seat ECU) - Outer mirror control ECU
|
S28-9 (MPX2) - R30-25 (MPX1)
|
OK:
There is continuity between the connectors.
HINT:
If there is an open in any wire harness, repair it.
| NG |
|
REPAIR OR REPLACE HARNESS AND CONNECTOR
|
| OK |
|
REPLACE POSITION CONTROL ECU ASSEMBLY (DRIVER SEAT ECU)
|
|