| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000018H3001X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: THEFT DETERRENT: THEFT DETERRENT SYSTEM: DATA LIST / ACTIVE TEST; 2007 MY LX470 [08/2006 - ] | ||
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
(a) Connect the intelligent tester (with CAN VIM) to the DLC3.
(b) Turn the ignition switch ON.
(c) Read the DATA LIST by following the displays on the tester.
Theft warning ECU assembly:
|
Item |
Measurement Item / Display (Range) |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
HOOD COURTESY SW |
Engine hood courtesy switch signal / ON or OFF |
ON: Engine hood is open OFF: Engine hood is closed |
- |
|
GLS BRK DETECT |
Glass breakage sensor detect / ON or OFF |
ON: Glass breakage sensor operates OFF: Glass breakage sensor does not operate |
|
|
KEY UNLK WRN SW |
Unlock warning switch signal / ON or OFF |
ON: Key is inserted in ignition key cylinder OFF: No key is inserted in ignition key cylinder |
|
|
IG SW |
Ignition switch signal / ON or OFF |
ON: Key is ON or START position OFF: Key is OFF or ACC position |
|
|
PASSIVE MODE |
Passive mode / ON or OFF |
ON: Switched from active mode OFF: Switched to active mode |
|
|
WARN BY GLS SEN |
Warning by glass breakage sensor / ON or OFF |
ON: Warns when glass breakage is detected OFF: Does not warn when glass breakage is detected |
|
|
WARNING (HORN) |
Warning by horn / ON or OFF |
ON: Switched from armed state to alarm sounding state OFF: Switched from alarm sounding state to armed state or disarmed state |
|
|
ENTRY DELAY |
Entry delay time during passive mode / 0s, 14s or 30s |
0s: Entry delay time is 0 sec. 14s: Entry delay time is 14 sec. 30s: Entry delay time is 30 sec. |
2. PERFORM ACTIVE TEST
HINT:
Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time.
The DATA LIST can be displayed during the ACTIVE TEST.
(a) Connect the intelligent tester (with CAN VIM) to the DLC3.
(b) Turn the ignition switch ON.
(c) Perform the ACTIVE TEST by following the displays on the tester.
Theft warning ECU assembly:
|
Item |
Test Detail |
Diagnostic Note |
|---|---|---|
|
SECURITY INDIC |
Security indicator light ON / OFF |
Connect terminals TC and CG of DLC3 |
|
SECURITY HORN2 |
Security horn ON / OFF |
- |
|
|