Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM0000018L7008X
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: DATA LIST / ACTIVE TEST; 2007 MY LX470 [08/2006 -        ]

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the intelligent tester to read the DATA LIST allow the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch ON.

(c) Following the display on the intelligent tester, read the "DATA LIST".

Tire Pressure warning ECU and receiver

Tester Display

Test Part

Control Range

Diagnostic Note

MODE STATUS

Tire pressure warning system mode/

NORMAL or REG 2nd or REG M or TEST

NORMAL: Normal mode

TEST: Test mode

-

MAIN TIRE

Number of main tire IDs to be registered /

0 or 1 or 2 or 3 or 4 or 5

0 to 5 should be displayed

-

2ND TIRE

Number of 2nd tire IDs to be registered /

0 to 1 or 2 or 3 or 4 or 5

0 to 5 should be displayed

-

SELECT SW

Select switch /

Main or 2nd

MAIN: Not pressed

2nd: Pressed

-

INITIAL SW

Tire pressure warning reset switch /

ON or OFF

ON: Switch on

OFF: Switch off

-

VEHICLE SPEED

Vehicle speed reading /

min.: 0 km/h (0 mph)

max.: 255 km/h (158 mph)

Actual vehicle speed

Speed indicated on the combination meter

REGIT ID1 CODE

Registered ID1 code /

min.: 0

max.: FFFFFFF*1

The ID No. registered in the transmitter ID1 is displayed

-

REGIT ID2 CODE

Registered ID2 code /

min.: 0

max.: FFFFFFF*1

The ID No. registered in the transmitter ID2 is displayed

-

REGIT ID3 CODE

Registered ID3 code /

min.: 0

max.: FFFFFFF*1

The ID No. registered in the transmitter ID3 is displayed

-

REGIT ID4 CODE

Registered ID4 code /

min.: 0

max.: FFFFFFF*1

The ID No. registered in the transmitter ID4 is displayed

-

REGIT ID5 CODE

Registered ID5 code /

min.: 0

max.: FFFFFFF*1

The ID No. registered in the transmitter ID5 is displayed

-

TRANS STATUS

ID code transmission status /

FINISH or NOW

FINISH or NOW

-

TRANS PLACE

ID code transmission setting /

MAIN or 2nd

MAIN or 2nd

-

TIREPRESS1

ID1 tire inflation pressure /

min.: Absolute pressure / 0 kPa (0 kgf/cm 2 , 0 psi), Relative pressure / -100 kPa (-1 kgf/cm 2 , -14 psi)

max.: Absolute pressure / 637.5 kPa (6.5 kgf/cm 2 , 92.5 psi), Relative pressure / 537.5 kPa (5.4 kgf/cm 2 , 78 psi)

Actual tire inflation pressure

If 0 kPa (0 kgf/cm 2 , 0 psi) is displayed for absolute pressure or -100 kPa (-1 kgf/cm 2 , -14 psi) is displayed for relative pressure, data has not been received.*2

TIREPRESS2

ID2 tire inflation pressure /

min.: Absolute pressure / 0 kPa (0 kgf/cm 2 , 0 psi), Relative pressure / -100 kPa (-1 kgf/cm 2 , -14 psi)

max.: Absolute pressure / 637.5 kPa (6.5 kgf/cm 2 , 92.5 psi), Relative pressure / 537.5 kPa (5.4 kgf/cm 2 , 78 psi)

Actual tire inflation pressure

If 0 kPa (0 kgf/cm 2 , 0 psi) is displayed for absolute pressure or -100 kPa (-1 kgf/cm 2 , -14 psi) is displayed for relative pressure, data has not been received.*2

TIREPRESS3

ID3 tire inflation pressure /

min.: Absolute pressure / 0 kPa (0 kgf/cm 2 , 0 psi), Relative pressure / -100 kPa (-1 kgf/cm 2 , -14 psi)

max.: Absolute pressure / 637.5 kPa (6.5 kgf/cm 2 , 92.5 psi), Relative pressure / 537.5 kPa (5.4 kgf/cm 2 , 78 psi)

Actual tire inflation pressure

If 0 kPa (0 kgf/cm 2 , 0 psi) is displayed for absolute pressure or -100 kPa (-1 kgf/cm 2 , -14 psi) is displayed for relative pressure, data has not been received.*2

TIREPRESS4

ID4 tire inflation pressure /

min.: Absolute pressure / 0 kPa (0 kgf/cm 2 , 0 psi), Relative pressure / -100 kPa (-1 kgf/cm 2 , -14 psi)

max.: Absolute pressure / 637.5 kPa (6.5 kgf/cm 2 , 92.5 psi), Relative pressure / 537.5 kPa (5.4 kgf/cm 2 , 78 psi)

Actual tire inflation pressure

If 0 kPa (0 kgf/cm 2 , 0 psi) is displayed for absolute pressure or -100 kPa (-1 kgf/cm 2 , -14 psi) is displayed for relative pressure, data has not been received.*2

TIREPRESS5

ID5 tire inflation pressure /

min.: Absolute pressure / 0 kPa (0 kgf/cm 2 , 0 psi), Relative pressure / -100 kPa (-1 kgf/cm 2 , -14 psi)

max.: Absolute pressure / 637.5 kPa (6.5 kgf/cm 2 , 92.5 psi), Relative pressure / 537.5 kPa (5.4 kgf/cm 2 , 78 psi)

Actual tire inflation pressure

If 0 kPa (0 kgf/cm 2 , 0 psi) is displayed for absolute pressure or -100 kPa (-1 kgf/cm 2 , -14 psi) is displayed for relative pressure, data has not been received.*2

TIRE TEMP1

ID1 temperature in tire /

min.: -40°C (-40°F)

max.: 215°C (419°F)

Actual tire temperature

If -40°C (-40°F) is displayed, the data have not been received.

TIRE TEMP2

ID2 temperature in tire /

min.: -40°C (-40°F)

max.: 215°C (419°F)

Actual tire temperature

If -40°C (-40°F) is displayed, the data have not been received.

TIRE TEMP3

ID3 temperature in tire /

min.: -40°C (-40°F)

max.: 215°C (419°F)

Actual tire temperature

If -40°C (-40°F) is displayed, the data have not been received.

TIRE TEMP4

ID4 temperature in tire /

min.: -40°C (-40°F)

max.: 215°C (419°F)

Actual tire temperature

If -40°C (-40°F) is displayed, the data have not been received.

TIRE TEMP5

ID5 temperature in tire /

min.: -40°C (-40°F)

max.: 215°C (419°F)

Actual tire temperature

If -40°C (-40°F) is displayed, the data have not been received.

BATT VOLT1

ID1 battery voltage /

OVER or LESS

OVER

-

BATT VOLT2

ID2 battery voltage /

OVER or LESS

OVER

-

BATT VOLT3

ID3 battery voltage /

OVER or LESS

OVER

-

BATT VOLT4

ID4 battery voltage /

OVER or LESS

OVER

-

BATT VOLT5

ID5 battery voltage /

OVER or LESS

OVER

-

SELECT SW INFO

Tire pressure warning select switch setting information /

WITH or WITHOUT

WITH or WITHOUT

-

INITIAL SW INFO

Tire pressure warning reset switch setting information /

WITH or WITHOUT

WITH or WITHOUT

-

INIT THRESHOLD1

ID1 initial threshold of low pressure /

min.: 0 kPa (0 kgf/cm 2 , 0 psi),

max.: 637.5 kPa (6.5 kgf/cm 2 , 92 psi)

Tire pressure after initialization

-

INIT THRESHOLD2

ID2 initial threshold of low pressure /

min.: 0 kPa (0 kgf/cm 2 , 0 psi),

max.: 637.5 kPa (6.5 kgf/cm 2 , 92 psi)

Tire pressure after initialization

-

INIT THRESHOLD3

ID3 initial threshold of low pressure /

min.: 0 kPa (0 kgf/cm 2 , 0 psi),

max.: 637.5 kPa (6.5 kgf/cm 2 , 92 psi)

Tire pressure after initialization

-

INIT THRESHOLD4

ID4 initial threshold of low pressure /

min.: 0 kPa (0 kgf/cm 2 , 0 psi),

max.: 637.5 kPa (6.5 kgf/cm 2 , 92 psi)

Tire pressure after initialization

-

INIT THRESHOLD5

ID5 initial threshold of low pressure /

min.: 0 kPa (0 kgf/cm 2 , 0 psi),

max.: 637.5 kPa (6.5 kgf/cm 2 , 92 psi)

Tire pressure after initialization

-

# CODES

Number of DTC recorded/

min.: 0

max.: 255

0

-

HINT:

*1: Displayed only when the ID No. is not registered.

*2: It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 2007 MY LX470 [08/2006 -        ]; TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2121/21,...,C2185/85; No Signal from Transmitter ID1 in Main Mode .