Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM0000018NK009X
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: STEERING COLUMN: STEERING COLUMN ASSEMBLY: INSPECTION; 2007 MY LX470 [08/2006 -        ]

INSPECTION

1. INSTALL STEERING LOCK OPERATION

(a) Check that the steering lock mechanism operates properly.

(b) If necessary, replace the key cylinder.

(1) Place the ignition key at the ACC position.

(2) Using a screwdriver, push down the stopper pin of the cylinder, and pull out the key cylinder.

(3) Install a new cylinder.

HINT:

Make sure the key is at the ACC position.

2. INSPECT IGNITION SWITCH 2007 MY LX470 [08/2006 -        ]; 2UZ-FE STARTING: IGNITION SWITCH: ON-VEHICLE INSPECTION+

3. INSPECT KEY UNLOCK WARNING SWITCH 2007 MY LX470 [08/2006 -        ]; 2UZ-FE STARTING: IGNITION SWITCH: ON-VEHICLE INSPECTION+

4. INSPECT KEY INTER LOCK SOLENOID 2007 MY LX470 [08/2006 -        ]; A750F AUTOMATIC TRANSMISSION: SHIFT LOCK SYSTEM: INSPECTION+

5. INSPECT UPPER BEARING

(a) Check the bearing rotation condition and check for abnormal noise.

If the bearing is worn or damaged, replace the column upper tube.

(b) Coat the bearing with molybdenum disulfide lithium base grease.

6. INSPECT LOWER BEARING

(a) Check the bearing rotation condition of the main shaft assembly and check for abnormal noise.

If necessary, replace the bearing.

(b) Coat the bearing with molybdenum disulfide lithium base grease.