| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000018QJ005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: AIR CONDITIONING: COMPRESSOR AND MAGNETIC CLUTCH: DISASSEMBLY; 2007 MY LX470 [08/2006 - ] | ||
DISASSEMBLY
1. REMOVE PRESSURE PLATE
|
(a) Using SST and a socket wrench, remove the shaft bolt. SST: 07112-76060 Torque: 13.2 N·m {135 kgf·cm, 9ft·lbf} |
|
|
(b) Install SST on the pressure plate. SST: 07112-66040 |
|
|
(c) Using SST and a socket wrench, remove the pressure plate. SST: 07112-66040 SST: 07112-76060 |
|
|
(d) Remove the shims from the pressure plate. |
|
2. REMOVE ROTOR
(a) Using SST, remove the snap ring.
SST: 95994-10020
|
(1) At the time of reassembly. NOTICE: The snap ring should be installed so that beveled side facing up. |
|
|
(b) Using a plastic-faced hammer, tap the rotor off the shaft. NOTICE: Be careful not to damage the pulley when tapping on the rotor. |
|
3. REMOVE STATOR COIL
|
(a) Disconnect the stator lead wire from the compressor housing. |
|
(b) Using SST, remove the snap ring.
SST: 95994-10020
|
(1) At the time of reassembly. NOTICE: The snap ring should be installed so that its beveled side facing up. |
|
|
(c) Remove the stator. |
|
|
|