| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000018RI005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: DRIVE SHAFT: FRONT DRIVE SHAFT: DISASSEMBLY; 2007 MY LX470 [08/2006 - ] | ||
DISASSEMBLY
1. REMOVE INBOARD JOINT BOOT CLAMP
(a) Using a screwdriver, unstake and remove the 2 inboard joint boot clamps.
|
2. REMOVE INBOARD JOINT TULIP (a) Place matchmarks on the inboard joint tulip and outboard joint shaft. NOTICE: Do not punch the marks. (b) Using a screwdriver, remove the snap ring from the outboard joint shaft. (c) Remove the inboard joint tulip from the outboard joint shaft. |
|
|
3. DISASSEMBLE INBOARD JOINT (a) Place matchmarks on the outboard joint shaft, inner race and cage. NOTICE: Do not punch the marks. (b) Remove the 6 balls. (c) Slide the cage to the outboard joint side. (d) Using a snap ring expander, remove the snap ring. (e) Using a brass bar and hammer, tap out the inner race. NOTICE: Be careful not to damage the inner race. (f) Remove the cage. |
|
4. REMOVE INBOARD JOINT BOOT
5. REMOVE OUTBOARD JOINT BOOT
(a) Using a screwdriver, unstake the 2 outboard joint boot clamps.
HINT:
If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter or pliers to remove them.
(b) Remove the 2 outboard joint boot clamps and outboard joint boot.
NOTICE:
Do not disassemble the outboard joint.
6. REMOVE FRONT DRIVE SHAFT DUST COVER
(a) Using a screwdriver and hammer, tap out the dust cover from the inboard joint tulip.
7. REMOVE FRONT AXLE HUB DUST SEAL
(a) Using a screwdriver and hammer, tap out the dust seal from the outboard joint shaft.
|
|