| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000018RR005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: AXLE: FRONT AXLE HUB: REMOVAL; 2007 MY LX470 [08/2006 - ] | ||
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
|
2. REMOVE DISC BRAKE CYLINDER ASSEMBLY (a) Remove the bolt and disconnect the flexible hose from the steering knuckle. (b) Remove the 2 bolts, washers and brake cylinder. (c) Support the brake cylinder securely. |
|
3. REMOVE FRONT AXLE OUTER SHAFT FLANGE
(a) Using a screwdriver and hammer, remove the grease cap from the flange.
|
(b) Using a snap ring expander, remove the snap ring. |
|
(c) Remove the 6 nuts and 6 washers.
(d) Install the 6 nuts temporarily to protect the threads of the stud bolts.
|
(e) Using a brass bar and hammer, tap on the bolt heads and remove the 6 nuts and cone washers. |
|
(f) Remove the flange and gasket.
4. REMOVE AXLE HUB WITH DISC
(a) Using a screwdriver, release the lock washer.
|
(b) Using SST, remove the lock nut. SST: 09607-60020 |
|
(c) Remove the lock washer.
(d) Using SST, remove the adjusting nut.
SST: 09607-60020
NOTICE:
Be careful not to damage the ABS speed sensor rotor and oil seal.
(e) Remove the axle hub with disc.
(f) Remove the claw washer and bearing from the axle hub.
|
|