| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM0000018S5005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: AXLE: REAR AXLE SHAFT: DISASSEMBLY; 2007 MY LX470 [08/2006 - ] | ||
DISASSEMBLY
1. REMOVE BEARING ABS SPEED SENSOR ROTOR
(a) Attach 4 nuts to the serration bolts and using a hammer, tap out the serration bolts from the backing plate.
NOTICE:
Do not reuse the nuts previously removed from the vehicle.
|
(b) Grind the retainer and sensor rotor surfaces using a grinder, then pry them out with a chisel and hammer. |
|
2. REMOVE REAR AXLE SHAFT SNAP RING
(a) Using a snap ring expander, remove the snap ring from the axle shaft.
3. REMOVE REAR AXLE SHAFT
(a) Attach 4 washers and nut to the serration bolts, then torque the nuts to install the serration bolts to the backing plate.
(b) Remove the 4 nuts and washers from the serration bolts.
|
(c) Position SST on the backing plate with the 4 nuts. SST: 09521-25011 SST: 09521-25023 |
|
(d) Using a press, remove the axle shaft, bearing retainer and plate washer from the backing plate.
(e) Remove the SST.
|
4. REMOVE OIL DEFLECTOR (a) Using a brass bar and hammer, tap out the 5 hub bolts, oil deflector and gasket. |
|
|
5. REMOVE REAR AXLE SHAFT OUTER OIL SEAL (a) Using SST, tap out the oil seal. SST: 09308-00010 |
|
|
6. REMOVE REAR AXLE BEARING CASE (a) Attach 4 nuts to the serration bolts and remove the serration bolts and bearing case from the backing plate using a hammer. NOTICE: Do not reuse the nuts previously removed from the vehicle. |
|
|
7. REMOVE REAR AXLE SHAFT BEARING (a) Using SST and a press, press out the bearing. SST: 09950-60020 09951-00810 SST: 09950-70010 09951-07100 |
|
|
|