AXLE: REAR AXLE SHAFT: REASSEMBLY; 2007 MY LX470 [08/2006

Last Modified: 7-3-2017	6.8:8.0.40	Doc ID: RM0000018S6005X
Model Year Start: 2007	Model: LX470	Prod Date Range: [08/2006 - ]
Title: AXLE: REAR AXLE SHAFT: REASSEMBLY; 2007 MY LX470 [08/2006 - ]

REASSEMBLY

1. INSTALL REAR AXLE SHAFT BEARING

(a) Using SST and a press, press in the bearing.

SST: 09950-60020

09951-00890

2. INSTALL REAR AXLE BEARING CASE LH

(a) Position the backing plate on the bearing case and using a press and 2 socket wrenches, press in the 4 serration bolts.

3. INSTALL REAR AXLE SHAFT OUTER OIL SEAL

(a) Using SST and a hammer, tap in a new oil seal.

SST: 09950-60020

09951-00810

SST: 09950-70010

09951-07100

(b) Coat MP grease to the oil seal lip.

4. INSTALL BRAKE DRUM OIL DEFLECTOR

(a) Position a new gasket and the oil deflector on the axle shaft and install a washer and nut to a new hub bolt, as shown in the illustration, and install the 5 hub bolts by torquing the nut.

5. INSTALL AXLE SHAFT

(a) Install the backing plate, plate washer and bearing retainer on the axle shaft.

(b) Using SST and a press, install the axle shaft into the backing plate.

SST: 09631-12090

SST: 09950-60020

09951-01030

6. INSTALL REAR AXLE SHAFT SNAP RING

(a) Using a snap ring expander, install a new snap ring.

7. INSTALL ABS SPEED SENSOR ROTOR

(a) Using SST and a press, press in a new ABS speed sensor rotor and bearing retainer.

SST: 09631-12090

SST: 09950-60020

09951-01030

Standard length A:

170.7 +- 1.0 mm (6.720 +- 0.039 in.)

NOTICE:

If this installation measurement is not followed precisely, oil leaks and other mechanical failures will result. Follow the assembly instructions closely, and confirm that parts have been installed according to the standard length measurement.

HINT:

If may be easier to verify the installation by adding the length of the SST to the standard length, and then measuring the height from the surface of the press.