| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM00000195U005X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: WINDSHIELD / WINDOWGLASS: BACK DOOR GLASS: REMOVAL; 2007 MY LX470 [08/2006 - ] | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE ASSIST GRIP PLUG
3.
REMOVE ASSIST GRIP
![2007 MY LX470 [08/2006 - ]; ENGINE HOOD / DOOR: BACK DOOR: DISASSEMBLY+](../../../../stylegraphics/info.gif "2007 MY LX470 [08/2006 - ]; ENGINE HOOD / DOOR: BACK DOOR: DISASSEMBLY+")
4. REMOVE BACK DOOR INSIDE HANDLE BEZEL
5.
REMOVE BACK DOOR GARNISH CENTER
6.
REMOVE BACK DOOR GARNISH
7.
REMOVE REAR WIPER ARM
|
8. REMOVE BACK WINDOW MOULDING OUTSIDE (a) Using a knife, cut off the moulding as shown. NOTICE: Do not damage the body with the knife. |
|
9. REMOVE BACK DOOR GLASS
(a) Disconnect the connector.
(b) Push piano wire through between the body and glass from the interior.
|
(c) Tie both wire ends to wooden blocks or similar object. HINT: Apply protective tape to the outer surface to keep the surface from being scratched. NOTICE: When separating the glass, take care not to damage the paint and exterior ornaments. |
|
(d) Cut the adhesive by pulling the piano wire around it.
(e) Remove the glass.
NOTICE:
Leave as much adhesive on the body as possible when cutting off the glass.
|
10. CLEAN VEHICLE BODY (a) Clean and shape the contact surface of the vehicle body. (1) On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration. HINT: Leave as much adhesive on the vehicle body as possible. NOTICE: Be careful not to damage the vehicle body. (b) Clean the contact surface of the vehicle body with cleaner. HINT: Even if all the adhesive has been removed, clean the vehicle body. |
|
|
11. CLEAN BACK DOOR GLASS (a) Using a scraper, remove the damaged stoppers and adhesive sticking to the glass. (b) Clean the outer edges of the glass with white gasoline. NOTICE:
|
|
|
|