| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM000001970003X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATION; 2007 MY LX470 [08/2006 - ] | ||
INSTALLATION
NOTICE:
Do not heat the clip and vehicle body excessively.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
-
When installing the clip, heat the clip and vehicle body using a heat light.
Standard heating temperature:
Item
Temperature
Clip
20 to 30°C (68 to 86°F)
Vehicle Body
40 to 60°C (104 to 140°F)
1. INSTALL NO. 2 ROOF DRIP SIDE FINISH MOULDING CLIP
If the No. 2 roof drip side finish moulding clip is accidentally removed:
(a) Using a heat light, heat the body mounting surface.
NOTICE:
Do not heat the vehicle body excessively.
(b) Remove the adhesive tape and adhesive from the body.
(c) Wipe off any tape adhesive residue with cleaner.
(d) Using a heat light, heat the body and clip.
NOTICE:
Do not heat the vehicle body and clip excessively.
(e) Install the clip.
2. REMOVE NO. 2 ROOF DRIP SIDE FINISH MOULDING CENTER LH
(a) Install the 3 finish moulding centers to the roof drip side finish moulding.
3. INSTALL ROOF DRIP SIDE FINISH MOULDING LH
|
|