Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM0000019ZZ008X
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: WIPER AND WASHER: FRONT WIPER MOTOR AND LINK: INSTALLATION; 2007 MY LX470 [08/2006 -        ]

INSTALLATION

1. INSTALL WINDSHIELD WIPER LINK ASSEMBLY

(a) Install the wiper link through the service hole, and then install the 6 bolts.

Torque:

5.4 N·m {55 kgf·cm, 48in·lbf}

HINT:

When installing the wiper link, connect the claw of the wiper link to the panel.

2. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

(a) Connect the wiper motor to the wiper link.

(b) Install the 4 bolts.

(c) Connect the connector.

3. INSTALL COWL TOP VENTILATOR LOUVER RH

4. INSTALL COWL TOP VENTILATOR LOUVER LH

5. INSTALL HOOD TO COWL TOP SEAL

6. INSTALL WIPER ARM

(a) Operate the wiper once and turn the wiper switch OFF.

(b) Install the wiper arm and tighten the nuts by hand.

(c) Adjust the installation position of the wiper arm to the positions shown in the illustration.

Standard Measurement:

Area

Measurement

A

Approx. 40 mm (1.57 in.)

B

Approx. 16 - 26 mm (0.63 - 1.02 in.)

(d) Tighten the nuts.

Torque:

20 N·m {204 kgf·cm, 15ft·lbf}

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION

(a) Perform initialization 2007 MY LX470 [08/2006 -        ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION .

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.