Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM000001ATX004X
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: INSTRUMENT PANEL: INSTRUMENT PANEL SAFETY PAD: DISASSEMBLY; 2007 MY LX470 [08/2006 -        ]

DISASSEMBLY

1. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

3. REMOVE DEFROSTER NOZZLE ASSEMBLY

4. REMOVE CENTER BRACKET

5. REMOVE NO. 1 HEATER TO REGISTER DUCT

6. REMOVE INSTRUMENT PANEL WIRE HARNESS

7. REMOVE NO. 5 HEATER TO REGISTER DUCT

8. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

(a) Remove the 3 nuts and the front passenger airbag assembly.

Torque:

6.0 N·m {61 kgf·cm, 53in·lbf}

CAUTION:

  • Do not store the front passenger airbag assembly with the airbag deployment side facing down.
  • Never disassemble the front passenger airbag assembly.

(b) At the time of reassembly:

NOTICE:

  • Make sure that the front passenger airbag assembly is installed with the specified torque.
  • If the front passenger airbag assembly has been dropped, or if there are cracks, dents or other defects in the case or the connector, replace the front passenger airbag assembly with a new one.
  • When installing the front passenger airbag assembly, take care that the wiring does not interfere with other parts and is not pinched between other parts.

9. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

10. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY