| Last Modified: 7-3-2017 | 6.8:8.0.40 | Doc ID: RM000001B2E006X |
| Model Year Start: 2007 | Model: LX470 | Prod Date Range: [08/2006 - ] |
| Title: BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION; 2007 MY LX470 [08/2006 - ] | ||
INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. INSTALL REAR SPEED SENSOR LH
(a) Install the speed sensor with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71in·lbf}
NOTICE:
Keep the sensor tip and sensor installation hole free from foreign matter.
(b) Install the sensor wire harness to the frame, upper control arm and axle housing with the 6 resin clips.
NOTICE:
Do not twist the sensor wire when installing it.
(c) Install the clamp bolt to the upper control bracket.
Torque:
13 N·m {130 kgf·cm, 9ft·lbf}
NOTICE:
Do not twist the sensor wire when installing it.
|
(d) Connect the speed sensor connector. NOTICE: Do not twist the sensor wire when installing it. |
|
2. INSTALL REAR WHEEL
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a)
Perform initialization
![2007 MY LX470 [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](../../../../stylegraphics/info.gif "2007 MY LX470 [08/2006 - ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION")
.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK ABS SPEED SENSOR SIGNAL
(a)
Check the ABS speed sensor signal
.
|
|