Last Modified: 7-3-2017 6.8:8.0.40 Doc ID: RM000001BHB004X
Model Year Start: 2007 Model: LX470 Prod Date Range: [08/2006 -           ]
Title: SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION; 2007 MY LX470 [08/2006 -        ]

INSTALLATION

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing 2007 MY LX470 [08/2006 -        ]; SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: PRECAUTION .

1. INSTALL REAR AIRBAG SENSOR

(a) Install the airbag sensor with the 2 bolts.

Torque:

17.5 N·m {178 kgf·cm, 13ft·lbf}

CAUTION:

  • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(b) Check that there is no looseness in the installation parts of the airbag sensor.

(c) Connect the connector.

2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY

3. INSTALL STRIKER PLATE

4. INSTALL REAR NO. 2 SEAT ASSEMBLY

5. INSTALL REAR MAT SET PLATE

6. INSTALL SEAT BELT OUTER ANCHOR COVER

7. INSTALL REAR DOOR OPENING TRIM WEATHER STRIP

8. INSTALL REAR DOOR SCUFF PLATE

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. PERFORM INITIALIZATION

(a) Perform initialization 2007 MY LX470 [08/2006 -        ]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION .

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light 2007 MY LX470 [08/2006 -        ]; SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: DIAGNOSIS SYSTEM .