REASSEMBLY

1. INSTALL OIL SEAL (a) Using SST and a hammer, install a new oil seal. SST: 09950-60010 09951-00310 SST: 09950-70010 09951-07100

2. INSTALL HEIGHT CONTROL PUMP & MOTOR ASSEMBLY

(a) Install the pump motor with 2 bolts.

Torque:

5.2 N·m {53 kgf·cm, 46in·lbf}

3. INSTALL HEIGHT CONTROL MOTOR JOINT

4. INSTALL HEIGHT CONTROL PUMP SUB-ASSEMBLY

(a) Install a new O-ring to the housing.

(b) Align the pin of pump sub-assembly and housing. NOTICE: Be careful not so that the portion does not interfere with other portions.

(c) Using a hexagon wrench, install the 2 bolts.

Torque:

5.6 N·m {58 kgf·cm, 50in·lbf}

5. INSTALL HEIGHT CONTROL PUMP COVER

(a) Install a new O-ring and the pump cover with 3 bolts.

Torque:

15 N·m {150 kgf·cm, 11ft·lbf}

6. INSTALL FLUID TEMPERATURE SENSOR

(a) Install the fluid temperature sensor to the pump cover.

Torque:

22 N·m {220 kgf·cm, 16ft·lbf}

7. INSTALL FLUID PRESSURE SENSOR

(a) Install the fluid pressure sensor to the housing.

Torque:

44 N·m {450 kgf·cm, 33ft·lbf}

8. INSTALL SUSPENSION CONTROL OIL RESERVOIR BRACKET

(a) Install the 3 cushions to the reservoir bracket.

(b) Install the reservoir bracket with the 2 bolts to the housing.

Torque:

12 N·m {120 kgf·cm, 8ft·lbf}

9. INSTALL HEIGHT CONTROL RESERVOIR ASSEMBLY

(a) Install a new grommet to the reservoir.

(b) Install the strainer.

(c) Install the cover to the cap.

(d) Insert the flat-head screwdriver into the slit of the cover to the extent that it reaches the reservoir cap. Turn the cap and the cover together to install them.

(e) Install the reservoir with 2 bolts.

Torque:

6.9 N·m {70 kgf·cm, 61in·lbf}