| Last Modified: 11-27-2007 | 1.6 D | |
| Service Category: Vehicle Exterior | Section: Lighting (ext) | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000000PKJ01JX |
| Title: LIGHTING (EXT): LIGHTING SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING (2008 LX570) | ||
HOW TO PROCEED WITH TROUBLESHOOTING
HINT:
- Use these procedures to troubleshoot the lighting system.
- *: Use the Techstream.
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF COMMUNICATION SYSTEM* |
(a) Check for DTCs and make a note of any codes that are output
.
(b) Clear the DTCs.
(c) Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC, LIN communication DTC or lighting system DTC by simulating the symptoms indicated by the DTC.
Result
|
Result |
Proceed to |
|---|---|
|
DTC output does not reoccur |
A |
|
CAN communication system DTC output reoccurs |
B |
|
LIN communication system DTC output reoccurs |
C |
|
Lighting system DTC output reoccurs |
D |
| B |
|
Go to CAN COMMUNICATION SYSTEM |
| C |
|
Go to LIN COMMUNICATION SYSTEM |
| D |
|
Go to DIAGNOSTIC TROUBLE CODE CHART |
|
|
4. |
PROBLEM SYMPTOMS TABLE |
Result
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B |
|
Go to step 6 |
|
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check
.
(b) Terminals of ECU
.
(c) Data List / Active Test
.
|
|
6. |
ADJUST, REPAIR OR REPLACE |
|
|
7. |
CONFIRMATION TEST |
| NEXT |
|
END |
|
|