| Last Modified: 11-27-2007 | 1.6 J | |
| Service Category: Vehicle Exterior | Section: Window/Glass | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000000Y4601AX |
| Title: WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: DESCRIPTION (2008 LX570) | ||
|
Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch |
DESCRIPTION
If the auto up/down function does not operate, the cause may be one or more of the following:
- The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
- The master switch has a malfunction.
- The Hall-IC in the driver side power window regulator motor has a malfunction.
- There is an open or short in the wiring between the master switch and the driver side power window regulator motor.
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Check for DTCs
.
Result
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
B2311 is output |
B |
|
B2312 is output |
C |
|
B2313 is output |
D |
|
LIN communication system DTCs are output |
E |
|
|
2. |
CHECK MANUAL UP/DOWN FUNCTION |
(a) Check that the driver side door power window moves when the manual up/down function of the multiplex network master switch is operated
.
OK:
Driver side door power window moves.
|
|
3. |
READ VALUE USING TECHSTREAM (MULTIPLEX NETWORK MASTER SWITCH) |
(a) Use the Data List to check if the master switch is functioning properly
.
Master Switch
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
D Door P/W Auto SW |
Driver side power window auto up/down signal / ON or OFF |
ON: Driver side power window auto up/down switch operated OFF: Driver side power window switch not operated |
- |
OK:
Techstream display changes according to operation of multiplex network master switch.
|
|
|