1. INSTALL TRANSMISSION WIRE

(a) Coat the O-ring of the transmission wire connector with ATF.

(b) Install the 2 transmission wires with the 2 bolts. Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

(c) Connect the 2 transmission wire connectors. HINT: Push up the lever until the claw of the transmission wire connector makes a connection sound.

2. CONNECT TRANSMISSION WIRE

(a) Connect the 9 connectors to the solenoid valves.

(b) Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

Torque: 11 N·m (112 kgf·cm, 8 ft·lbf)

HINT:

Each bolt length is indicated below.

12 mm (0.472 in.) for bolt A

36 mm (1.41 in.) for bolt B

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

(a) Coat a new O-ring with ATF and install it to the oil strainer.

(b) Install the oil strainer with the 4 bolts.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

(a) Install the 4 transmission oil cleaner magnets to the oil pan.

(b) Install a new gasket and the oil pan with the 12 bolts. Torque: 7.4 N·m (75 kgf·cm, 65 in·lbf) NOTICE: Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface. Install the gasket so that there is no slack in the gasket, and make sure the entire circumference of the seal surface is level. Make sure that the 9 gasket drop prevention protrusions are set on the oil pan. When tightening the bolts of the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal surface.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. ADD AUTOMATIC TRANSMISSION FLUID