| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Drive Shaft/Propeller Shaft | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000018QT00LX |
| Title: DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: DISASSEMBLY (2008 LX570) | ||
DISASSEMBLY
NOTICE:
Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.
1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER ASSEMBLY
|
(a) Place matchmarks on the flange yoke and sleeve yoke or propeller shaft. |
|
(b) Using a brass bar and hammer, slightly tap in the spider bearing outer races. |
(c) Using 2 screwdrivers, remove the 4 snap rings from the grooves.
|
(d) Using SST, push out the bearing from the flange. SST: 09332-25010 HINT:
Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install. |
|
(e) Clamp the bearing outer race in a vise and tap off the flange with a hammer. HINT:
Remove the bearing on the opposite side using the same procedure. |
(f) Remove the flange yoke from the sleeve yoke (or propeller shaft).
(g) Install the 2 removed bearing outer races to the spider.
|
(h) Using SST, push out the bearing from the yoke. SST: 09332-25010 |
(i) Clamp the outer bearing race in a vise and tap off the yoke with a hammer.
HINT:
Remove the bearing on the opposite side using the same procedure.
|
|