| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Power Source/Network | Section: Battery/Charging | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000019QY00GX |
| Title: POWER OUTLETS (INT): VOLTAGE INVERTER: ON-VEHICLE INSPECTION (2008 LX570) | ||
ON-VEHICLE INSPECTION
1. INSPECT VOLTAGE INVERTER ASSEMBLY
HINT:
Remove interior parts so that the voltage inverter can be seen.
|
(a) Disconnect the voltage inverter connector. |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
K16-1 (IG) - K16-4 (GND) |
Engine switch on (IG) |
10 to 16 V |
|
GND (K16-4) - Body ground K16-4 (GND) - Body ground |
Always |
Below 1 V |
If the result is not as specified, repair or replace the harness or connector.
|
(c) Reconnect the voltage inverter connector. |
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
K16-3 (AC1) - K16-7 (AC2) |
Engine switch on (IG) Main switch on |
AC 115 V |
If the result is not as specified, replace the voltage inverter.
|
|