| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake Control/Dynamic Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000001B2J00CX |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL (2008 LX570) | ||
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT SKID CONTROL SENSOR WIRE LH
|
(a) Disconnect the connector from the front speed sensor. |
(b) Remove the bolt and harness clamp.
(c) Remove the nut and harness clamp.
|
(d) Remove the 2 bolts and 2 harness clamps. |
|
(e) Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire. |
4. REMOVE FRONT SPEED SENSOR LH
(a) Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.
NOTICE:
Pull out the sensor while trying as much as possible not to rotate it.
5. REMOVE FRONT SKID CONTROL SENSOR WIRE RH
|
(a) Disconnect the connector from the front speed sensor. |
(b) Remove the bolt and harness clamp.
(c) Remove the nut and harness clamp.
|
(d) Disconnect the connector. |
(e) Detach the connector from the skid control sensor clamp.
(f) Remove the bolt and skid control sensor clamp.
(g) Remove the 2 bolts and 2 harness clamps.
|
(h) Disconnect the connector and then remove the bolt, harness clamp and sensor wire. |
6. REMOVE FRONT SPEED SENSOR RH
(a) Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.
NOTICE:
Pull out the sensor while trying as much as possible not to rotate it.
|
|