| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000001J98008X |
| Title: DOOR / HATCH: BACK DOOR SUPPORT: INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. INSTALL BACK DOOR STAY ASSEMBLY LH
(a) When reusing the back door stay:
(1) Clean the threaded surface on the vehicle body with a non-residue solvent.
(2) Apply adhesive to the threads of the 2 bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
|
(3) Install the back door stay with the 2 bolts. Torque: 22 N·m (224 kgf·cm, 16 ft·lbf) CAUTION:
Install the door stay while supporting the back door with one hand. |
(4) Apply adhesive to the threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
|
(5) Install the back door stay bolt to the body. Torque: 18 N·m (184 kgf·cm, 13 ft·lbf) CAUTION:
Install the door stay bolt while supporting the back door with one hand. |
(b) When replacing the back door stay with a new one:
(1) Clean the threaded surface on the vehicle body with a non-residue solvent.
(2) Apply adhesive to the threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
|
(3) Install the back door stay bolt to the body. Torque: 18 N·m (184 kgf·cm, 13 ft·lbf) CAUTION:
Install the door stay bolt while supporting the back door with one hand. |
(4) Apply adhesive to the threads of the 2 bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
|
|
(5) Install the back door stay with the 2 bolts. Torque: 22 N·m (224 kgf·cm, 16 ft·lbf) CAUTION:
Install the door stay while supporting the back door with one hand. |
(6) Connect the ball joint of the back door stay bolt to the back door stay assembly LH.
(7) Check that the back door stay assembly is securely installed.
|
|