1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH

(a) Pack the upper arm ball joint with MP grease.

Grease capacity:

8.0 g (0.282 oz.)

(b) Apply MP grease to the locations shown in the illustration.

NOTICE:

Do not apply MP grease to the tapered or threaded parts of the ball joint.

(c) Install the dust cover to the upper arm.

(d) Using a snap ring expander, install the dust cover set ring. NOTICE: Make sure the set ring is securely installed in the groove.

2. INSTALL FRONT SUSPENSION UPPER ARM BUSH

(a) Using SST and a press, press in a new bush.

SST: 09710-26011

09710-05061

HINT:

Press in the rear side bush using the same procedure as for the front side.