SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL (2008 LX570)

Home › Vehicle Interior › Seat Belt › FRONT SEAT OUTER BELT ASSEMBLY

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Interior	Section: Seat Belt
Model Year: 2008	Model: LX570	Doc ID: RM000002LJS00SX
Title: SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL (2008 LX570)

REMOVAL

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

2. REMOVE FRONT DOOR SCUFF PLATE

3. REMOVE REAR STEP COVER

4. REMOVE REAR DOOR SCUFF PLATE

5. REMOVE CENTER PILLAR GARNISH COVER

6. REMOVE CENTER LOWER PILLAR GARNISH

HINT:

When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.
After moving the front seat, disconnect the cable from the negative (-) battery terminal.

NOTICE: