WIPER / WASHER: WASHER NOZZLE (for Front Side): REMOVAL (2008 LX570)

Home › Vehicle Exterior › Wiper/Washer › WASHER NOZZLE (for Front Side)

Last Modified: 11-27-2007		1.6 A
Service Category: Vehicle Exterior	Section: Wiper/Washer
Model Year: 2008	Model: LX570	Doc ID: RM000002M6D00QX
Title: WIPER / WASHER: WASHER NOZZLE (for Front Side): REMOVAL (2008 LX570)

REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH

2. REMOVE ENGINE ROOM SIDE COVER RH

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

w/ Navigation System:

After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

4. REMOVE UPPER RADIATOR SUPPORT SEAL

5. REMOVE FRONT FENDER MAIN SEAL LH

6. REMOVE FRONT FENDER MAIN SEAL RH

7. REMOVE FRONT WIPER ARM LH

8. REMOVE FRONT WIPER ARM RH

9. REMOVE HOOD TO COWL TOP SEAL

10. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

11. REMOVE WASHER NOZZLE SUB-ASSEMBLY

HINT:

Use the same procedures to remove the other washer nozzle.

(a) Detach the 3 claws and remove the washer nozzle.

(b) Disconnect the hose.