Home › Engine/Hybrid System › Cruise Control › CRUISE CONTROL MAIN SWITCH
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Cruise Control
Model Year: 2008 Model: LX570 Doc ID: RM000002MBX007X
Title: CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL CRUISE CONTROL MAIN SWITCH

(a) Install the switch with the 2 screws.

(b) Connect the connector and clamp.

2. INSTALL STEERING PAD SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 LX570)+

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 LX570)+

4. INSTALL LOWER NO. 3 STEERING WHEEL COVER SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 LX570)+

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

6. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 LX570) .

7. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+