| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Starting | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002MDO00DX |
| Title: 3UR-FE STARTING: STARTER: DISASSEMBLY (2008 LX570) | ||
DISASSEMBLY
1. REMOVE MAGNET STARTER SWITCH ASSEMBLY
|
(a) Remove the nut, and disconnect the lead wire from the terminal C. |
|
(b) Remove the 2 nuts and magnet starter switch. |
2. REMOVE STARTER DRIVE HOUSING ASSEMBLY
|
(a) Using a T30 "TORX" socket wrench, remove the 2 bolts. |
(b) Pull out the starter yoke and the starter commutator end frame together with the starter armature.
3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
|
(a) Remove the starter pinion drive lever. |
|
(b) Remove the 2 screws and end frame. NOTICE:
While holding down the lead wire, remove the starter commutator end frame. |
4. REMOVE STARTER ARMATURE ASSEMBLY
|
(a) Using a screwdriver, hold the spring back and disconnect the brush from the starter brush holder. |
(b) Disconnect the 4 brushes and remove the starter brush holder.
|
(c) Remove the starter armature from the starter yoke. |
5. REMOVE STARTER YOKE ASSEMBLY
(a) Remove the starter yoke from the starter center bearing clutch.
6. REMOVE STARTER ARMATURE PLATE
|
(a) Remove the starter armature plate from the starter center bearing clutch. |
7. REMOVE PLANETARY GEAR
|
(a) Remove the 3 planetary gears. |
|
|