| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002O9B006X |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. OPEN BACK DOOR
2. REMOVE ENGINE ROOM SIDE COVER LH
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
4. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly
.
5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Disconnect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
|
(b) Remove the 13 bolts and curtain shield airbag. |
|
|