| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Supplemental Restraint Systems | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002OF8007X |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: REMOVAL (2008 LX570) | ||
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. OPEN BACK DOOR
2. REMOVE ENGINE ROOM SIDE COVER LH
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
4. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
(a) Remove the rear no. 2 seat assembly
.
5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
6. REMOVE REAR STEP COVER
7. REMOVE REAR DOOR SCUFF PLATE LH
8. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
9. REMOVE REAR SEAT COVER CAP (for Semi Power Seat)
10. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
11. REMOVE REAR AIRBAG SENSOR
|
(a) Remove the bolt and rear airbag sensor. |
(b) Disconnect the connector.
|
|