| Last Modified: 11-27-2007 | 1.6 G | |
| Service Category: Vehicle Interior | Section: Theft Deterrent/Keyless Entry | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002XD5009X |
| Title: THEFT DETERRENT / KEYLESS ENTRY: ENTRY LOCK AND UNLOCK SWITCH (for Rear): INSPECTION (2008 LX570) | ||
INSPECTION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. INSPECT ENTRY LOCK AND UNLOCK SWITCH
(a) Disconnect the connector.
(b) Remove the outside handle.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
1 (TRG-) - 3 (TRG+) |
Lock switch not pushed (off) |
10 kΩ or higher |
|
1 (TRG-) - 3 (TRG+) |
Lock switch pushed (on) |
Below 1 Ω |
If the result is not as specified, replace the entry lock and unlock switch.
|
|